Application Guide — Concrete Potable Water Tanks
Interactive, on‑site steps for M‑Prime 104 (primer) and MaxLine 100 (lining/topcoat). Use the calculator and checklist to plan materials and verify quality.
Potable water safe (edit with your certification)
Concrete substrates
Elementor‑ready
M‑Prime 104 — Procedures
Est. crew time: 1–2 daysQA/QC — Acceptance Criteria
Use in pre‑start meetings and during ITP/hold points. Edit the criteria to match your specifications.
1) Concrete substrate condition
- Minimum compressive strength: ≥ 25 MPa (edit)
- Moisture content: < 5% (CM method) (edit)
- Surface profile: CSP 3–5 (ICRI) (edit)
2) Environmental conditions
- Air/Substrate temp during application: 10–30 °C (edit)
- Rel. humidity: < 80% (edit)
- Dew point: substrate at least 3 °C above dew point (edit)
3) DFT & Holiday testing
- DFT target (MaxLine 100): — μm (enter spec)
- Holiday test: High‑voltage spark test per NACE SP0188 (edit)